Mesa · Gilbert · Chandler · Tempe · Scottsdale · Phoenix
We clear out the nests and droppings, clean the area, then close off the gap under your array with a PVC-coated stainless steel mesh. Pigeons stay out, air still flows and the barrier blends into the roof.
Birds on ledges, AC units or the roof line too? See our pigeon control service. Pigeon control
The space under a rooftop array is shaded, sheltered and warm, which makes it a perfect nesting spot. Homes near a pool or any water source see it most. Once one pair moves in, more follow.
Pigeon droppings are acidic and eat away at tile and shingle over time. Nests trap leaves and desert debris against the roof, block drainage and sit right next to the wiring that runs your system. Most arrays are built to last 20 to 25 years, so closing the gap early protects the whole roof.
Acidic droppings break down tile and shingle, and blocked drainage holds water against the roof.
Nesting birds and other wildlife can chew or pull at the wiring under your panels.
Cooing at dawn, droppings on the patio and feathers in the yard all stop once the gap is sealed.
Tell us your panel count and ZIP. We price from the length of the array edge and the cleanup needed.
We remove nests and guano, clean the panels, then fit the mesh around the full perimeter.
Before-and-after shots of the cleanup and the finished barrier from every side.
Pigeon proofing is priced by the linear footage around your array, plus any cleanup needed before the mesh goes on. Heavy nesting takes more time, and we tell you that before we start.
Starting at $999
Before (left) · After (right)
Before (left) · After (right)
Finished install, two angles
Finished install, two angles
“James and his crew pigeon proofed our solar panels. Price was good and craftsmanship was five star. No more birds.”
A welded steel wire mesh coated in PVC that runs around the perimeter of your solar panels. It keeps pigeons and other wildlife from getting underneath.
The mesh clips to the panel frame without drilling into the panels. The installation is covered by a 10-year warranty.
By the linear footage around your array, plus any cleaning needed before installation.
Yes. We clear nests, feathers and guano and clean the panels before any mesh goes on, so nothing is sealed in.
Yes. We use pre-cut 5-foot sections shaped for Spanish tile, so they sit tight against the curves without gaps.
Barely. The black PVC-coated mesh sits under the panel edge and blends into the roof line.
Pigeon Proofing Cost and Per-Panel Pricing in Mesa Pigeon proofing cost in Mesa usually runs between $800 and $2,500 for a full solar array. Most homeowners land near the middle. The price depends on your panel count, roof shape, and how bad the birds are. That range sounds wide. But by the end of this […]
How Pigeon Nesting Reduces Solar Panel Efficiency Your panels are still on the roof. The sun still shows up every morning. So why is your power bill creeping back up? Out here we say the desert takes what you don’t watch. That includes your solar production. Most Mesa homeowners never look under their panels. There’s […]
The 10-Year Warranty on SunsUp Bird Proofing Installations You hire someone to keep birds off your roof. Six months later, the pigeons are back. That is the story I hear almost every week here in Mesa. Folks pay good money for bird proofing. Then they watch it sag, gap, or peel before the next monsoon […]
Not on the list? Call (480) 278-1219 and we will tell you straight.
